|
|
|
|
RECOVERY TANK
Recovery tank should be cleaned after every shift
| Steps | | Description |
| DRAINING
| |
- Park the machine on a level surface at an approved drainage site with the left rear of the machine beside the drain access.
- Engage the parking brake.
- Turn the machine OFF.
- Locate the drain hose on the left side of the machine beneath the engine access side door.
- Remove the flexible drain hose from its storage tray. Pull out the drain hose for the required reach to the access.
- Place the end of the drain hose on or in the approved drain access.
- Loosen and remove the drain plug.
- Drain the tank completely and reinstall the plug.
- Reposition the drain hose on its storage tray.
| |
| CLEANING
| |
- Position the machine at an approved drain area.
- Engage the parking brake.
- Shut off the machine.
- Remove the two 9" access caps at the sides of the unit.
- Remove the drain hose and position it over the approved drain opening.
- Loosen and remove the drain plug.
- Spray the tank with clean water, flushing all the sludge out of the access ports.
- Remove the foam cap on top of the exit tube. Rinse and reinstall.
- Drain the tank completely and reinstall the drain plug.
- Return the drain hose to the storage tray at the left side of the machine beneath the engine.
- Replace the 9" access caps removed in step four.
| |
|
